Idx CW-5 Manuel d'utilisateur télécharger pdf (Page 8)

‐6‐

CHAPTER 3 Operation Guide

3.1 Set up

The CW-5 dos not include the following, please prepare them before

use

● BNC cable for Video 2 or 3 cables

● XLR (5 pin) cable for audio 2 cables

* Please refer “ Chapter 2 Getting started “ for XLR connector

Pin assignments

● ENDURA series V-Mount batteries or external power supply

Note : External power supply

Use only an AC adaptor, or batteries with a DC output of 11V –

24V. The CW-5 DC-IN connector product number is

HR10A-7R-4PC（HIROSE.）Please refer “ Chapter 2 “ Getting

started “ for XLR connector Pin assignments.

3.2 Operating procedures

① Mount antennas (included) to CW-5TX and CW-5RX antenna

connectors.

② (Example of use) Connect CW-5TX to the battery mount of the

video camera, and CW-5RX to the monitor battery mount. If

either device does not have a V-Mount as standard use

applicable adapter.

③ Connect video camera video /audio output connector and

CW-5TX video/audio input connector cables. Also connect

monitor etc video/audio input connector and CW-5RX

video/audio output connector cables.

Please note that CW-5RX video output connector has two

outputs so it can be connected to two monitors simultaneously.

④ Connect a fully charged ENDURA battery to CW-5TX and CW-5RX

and turn the power on. (Power LED lights green.)

When external power supply is used, connect to DC-IN connector

and turn the power on.(Power LED lights Amber.)

Note:

When using an ENDURA battery, power is supplied to both CW-5

and video camera / monitors etc. However, when external power

supply is used power is only supplied to the CW-5, video camera,

monitors etc

must be powered separately.

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

Idx CW-5 Manuel d'utilisateur Page 8